Campbell-scientific NL100 Network Link Interface Manuale Utente Scaricare il pdf (Pagina 10)

NL100/105 Network Link Interface

The boot jumper is shown in Figure 2 below. The NL100/105 ships with this

jumper connected to only one post. Place the jumper so that it connects the two

posts.

Jumper

FIGURE 2. NL100/105 Jumper Placement

When the jumper is in place, open the HyperTerminal connection to the

NL100/105 and power up the device. The prompt "NL100 boot" will appear.

At this prompt, press <Enter> a few times to ring up the NL100/105. If

communication is successfully established, a message will be returned

indicating that the NL100/105 is initialized, along with the jumper setting (1 =

on, 0 = off), the TCP/IP address, Telnet port address, and current

communication configuration. If <Enter> is pressed again, the NL100/105

menu prompt will appear.

After reconfiguring the NL100/105 for communication,

the jumper should be disconnected. If this jumper

remains in place and power to the NL100/105 is cycled

off and back on, the NL100/105 will remain at the

"NL100 boot" prompt and will not boot up. This will

render the NL100/105 inaccessible via remote

communications.

WARNING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Nessun commento

Campbell-scientific NL100 Network Link Interface Manuale Utente Pagina 10