Campbell-scientific Getting Started Quickstart Guide Manuale Utente Scaricare il pdf (Pagina 2)

Open the Short Cut datalogger program creation software. In LoggerNet,

Short Cut is found under Program. In PC200W and PC400, Short Cut is

found in the Tools menu (or clicking on the red ‘clock’ icon).

• Use Short Cut to generate a basic datalogger program for all

the sensors that will be attached to the datalogger.

NOTE: Video tutorials covering datalogger programming and other

topics relevant to Campbell Scientic products are available at:

www.youtube.com/user/CampbellScientic

Follow the wiring diagram created by Short Cut to attach the sensors to the

datalogger. The wiring must match the diagram exactly for the sensors to

be measured correctly.

Use PC200W, PC400, LoggerNet, or RTDAQ to send the program to the

datalogger. Connect to the datalogger and view the real-time sensor

measurements in the Public table.

• Are the sensors making good measurements?

• If any sensor is not reading as expected, change the sensor

setting in Short Cut and repeat steps 6–7. Also verify that all

sensors wires are properly wired to the datalogger.

After giving the datalogger sucient time to take multiple measurements,

collect and review the data.

• Are the data values within the range of what is expected for

each sensor?

• Are the records being stored correctly to the data table(s) and

at the desired interval?

• If the data will be post-processed, is it in a le format that can

be used?

• Do the data values provide the information expected?

[Optional] Using the CRBasic Editor (not available in PC200W), expand the

program for any need beyond the basic Short Cut program. Take the time

to add comments to the program to explain.

Make an archival copy of the program and wiring diagram by saving them

to a second computer or storage device. Printing a hard copy to place in

the enclosure is also recommended.

Connect any communication devices to the datalogger.

• Congure and test each communication device.

• Refer to the device's manual on the ResourceDVD for additional

information.

• If using LoggerNet, use Network Planner to assist in the

conguration of each device. The Network Planner is in the

LoggerNet Launch | Tools category. Alternatively, use the

Device Conguration Utility (found on the Resource DVD) to set

up the device as indicated in the user manual.

Before deploying the system in the eld, assemble the system as much

as possible. Note what tools and hardware are needed to complete the

assembly. Make sure these tools and hardware are available for nal

assembly in the eld.

Deploy the system in the eld and test by repeating steps 5–7 to conrm

the system is functioning.

Short Cut

Campbell Scientic resources on the internet.

Manuals: Support Videos:

https://www.campbellsci.com/manuals https://www.youtube.com/user/CampbellScientic

1 2

READ THIS FIRST 1

Commenti su questo manuale

Nessun commento

Campbell-scientific Getting Started Quickstart Guide Manuale Utente Pagina 2

Commenti su questo manuale

Prodotti e manuali riguardandi Strumenti di misura Campbell-scientific Getting Started Quickstart Guide