Campbell-scientific HydroSense II Support Software User Guide Manuale Utente Scaricare il pdf (Pagina 32)

Section 4. Viewing Data

The following columns are in the data list:

TABLE 4-1. Data List

Element Description

TimeStamp HydroSense time when the measurement was made

Record

Number

Record numbers range from 1 to 65535

Zone Zone where this measurement is located

Latitude Latitude (°N of the equator) where this measurement was

made

Longitude Longitude (°E of the prime meridian) where this measurement

was made

Moisture ( % ) Volumetric water content (VWC) reported in percent (%).

Only water content is plotted on the Chart tab. Additional

raw measurements with units are shown in the Data tab

3. Timeline

The timeline allows the user to filter the points in the data list based on when

the measurements were taken. By default, the Select All Dates checkbox is

selected and all measurements are displayed. For information using the

timeline, see SECTION 4.1 Using the Timeline (p. 4-1).

4.3.2 Point Options

4.3.2.1 Find In Map View

To locate a given point in the Map View, right click on the desired row

(multiple rows can also be selected) in the Data View and choose Find In Map

View. Alternatively, double clicking on the row will perform the same

function.

4-6

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

Nessun commento

Campbell-scientific HydroSense II Support Software User Guide Manuale Utente Pagina 32