Campbell-scientific Sentek EnviroSCAN Access Tube Installation Guide Manuale Utente Scaricare il pdf (Pagina 25)

Installing EnviroSCAN, EnviroSMART & Diviner 2000 access tubes

7. Disengage the metal “tooth” on the tripod by turning the lever located on the tripod cylinder.

The metal “tooth” is designed to prevent the access tube from spinning during augering, and

should not be engaged while hammering in the access tube.

8. Insert the access tube with fitted cutting edge into the tripod guide tube, with cutting edge

facing downwards.

9. Select the Heavy duty dolly and insert it into the top of the access tube.

10. Use the sledge hammer to tap the dolly until the access tube is embedded approximately 5-

10 cm (2-4 inches) into the soil.

11. Place the auger inside the access tube and turn the auger handle clockwise to remove the

soil from inside the access tube. Continue to auger ahead of the access tube by

approximately 20 cm (8 inches). Use the pen mark on the rod to indicate when the desired

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 56 57

Nessun commento

Campbell-scientific Sentek EnviroSCAN Access Tube Installation Guide Manuale Utente Pagina 25